Quality System
Quality System & Standards
The standards, traceability and management arrangements that govern the work described on this site.
- Standard
- ISO/IEC 17025:2017
- Disciplines
- 3
Overview
Calibration and verification work is placed with laboratories holding accreditation to ISO/IEC 17025, and any accreditation referenced on a certificate belongs to the laboratory that performed the measurement. Scoping a job starts with matching the customer's machine, tolerance and required standard against that laboratory's published scope of accreditation before a quote is issued.
Standards Referenced
Work described on this site is performed under ISO/IEC 17025:2017.
Accreditation named anywhere here is the performing laboratory's, and its limits are the limits of that laboratory's published scope. Measurements outside the scope are reported as non-accredited and identified on the certificate rather than quietly included. Each accreditation statement names the laboratory that holds it.
What a quotation arrives with is explained on the accreditation documentation page.
Metrological Traceability
Measurements are traceable to the SI through NIST, by an unbroken chain of comparisons each carrying its own stated uncertainty. Certificates identify the reference standards used, the calibration date and the issue date, the method and standard applied, environmental conditions where they affect the result, and the reported measurement uncertainty with its coverage factor. Where adjustment or repair takes place, before and after results are both recorded, and a decision rule is documented and stated wherever a statement of conformity appears, under ISO/IEC 17025:2017.
The traceability statement belongs to the measurement, not to the building. On the certificate you will find the reference standard used, its calibration status at the time, and the chain by which it reaches the SI unit. Should that reference later fail its own calibration, the intervening work is reviewed and affected customers are contacted.
Equipment and Maintenance
Documented procedures govern request review, method selection, performance of the measurement, technical review before release, and a complaints-and-appeals process available to any customer disputing a result. Equipment categories covered include bridge, gantry and cantilever coordinate measuring machines, portable articulated arms, granite surface plates, gauge blocks, and ring and plug gauges. Accredited and non-accredited items are identified separately on both the quote and the certificate, and out-of-tolerance findings are reported with as-found data intact, before any adjustment, so a reverse-traceability impact assessment has evidence to work from.
Reference equipment is uniquely identified, held under controlled conditions, and recalibrated on a defined interval that is shortened when drift data justifies it. Equipment that is damaged, overloaded, or shown to give suspect results is removed from service and labeled until it has been checked and returned to use in writing.
Management System
The work sits inside a documented management system:
Controlled documents
Procedures carry issue and revision status.
Retained records
Retained for a defined period and retrievable against a certificate number.
Audit and review
Internal audit and management review run on a schedule.
Corrective action
Nonconforming work and improvement actions are tracked to closure, and their effectiveness is checked afterwards.
Impartiality and Complaints
Risks to impartiality are identified and controlled, and results are reported on their merits regardless of the commercial outcome. Complaints and appeals are a formal input to that system — the process, including the response commitment, is set out on the complaints policy page. How results should and should not be read is covered on the disclaimer page.
Need supplier-approval documentation?
Scope, method statements and traceability detail are supplied with the quotation.